Since rippled cracked acrylic has been mentioned, I thought I'd ask about
body panels, eg. hood, headlight lids, that curl or otherwise no longer meet
other panels flush. You can sand it down, but in a lot of cases it's too
pronounced. And you can't push it down...it will curl back up. And you
can't always glue it down...it may be a part that needs to pop up?
What have Bricklin people done? Heated it up and left pressure on it for
days???
#199 does not have extreme unmatched surfaces...just barely enough to annoy.
I apologize in advance as no doubt this topic was addressed. (I'm on
another mailing list where you can see and sort through previous messages
but I don't think it's possible here)?????
_________________________________________________________________
///
/// bricklin@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
///
|