alpines
[Top] [All Lists]

Re: Intake Manifold for Series V (Zenith-Stromberg)

To: Peter Noonan <peter.noonan@xtra.co.nz>
Subject: Re: Intake Manifold for Series V (Zenith-Stromberg)
From: chuck nicodemus <armorseal@spiretech.com>
Date: Sun, 30 Jun 2002 22:26:22 -0700
Whew~ I am glad I'm not close to you ..20:30 my time 16:30 yours . I'm 
goin to bed . You should go out and polish the Alpine.
chuck

Peter Noonan wrote:

> Aha, the word is legs.
> 
> Let's spread the word
> 
> LOL
> Peter
> ----- Original Message -----
> From: "chuck nicodemus" <armorseal@spiretech.com>
> To: "Kevin McLemore" <kmclemore@hotmail.com>
> Cc: <alpines@autox.team.net>
> Sent: Monday, July 01, 2002 4:34 PM
> Subject: Re: Intake Manifold for Series V (Zenith-Stromberg)
> 
> 
>> Kevin McLemore wrote:
>> 
>>> Hi, all..
>>> 
>>> So, the question is:
>>> 
>>> Does anyone out there have one of those cast clamps that secures the
>> 
> #2-#3
> 
>>> intake ports to the motor?
>>> 
>>> (To understand what I need, see the item listed as "Clamp D - PN
>> 
> 1214539" in
> 
>>> the picture here: http://www.team.net/www/rootes/rsb/68_18.html )
>> 
>> Kevin, some times if you don't have one , this is real simple. get a
>> small piece of channel iron the heavest you can find but less than 2"
>> wide. cut it to lenght and drill the center hole out. This will take
>> some time to fitt but a grinder and 3/8 drill will help the job be
>> quicker. then set the bolt stud in and with the legs towards you put a
>> good thick washer on and tighten it down.
>> 
>> Wish I could draw,   |__8__|  Legs are up here and stud in center.
>> good luck.
>> chuck

<Prev in Thread] Current Thread [Next in Thread>