Kevin McLemore wrote:
> Hi, all..
>
> So, the question is:
>
> Does anyone out there have one of those cast clamps that secures the #2-#3
> intake ports to the motor?
>
> (To understand what I need, see the item listed as "Clamp D - PN 1214539" in
> the picture here: http://www.team.net/www/rootes/rsb/68_18.html )
Kevin, some times if you don't have one , this is real simple. get a
small piece of channel iron the heavest you can find but less than 2"
wide. cut it to lenght and drill the center hole out. This will take
some time to fitt but a grinder and 3/8 drill will help the job be
quicker. then set the bolt stud in and with the legs towards you put a
good thick washer on and tighten it down.
Wish I could draw, |__8__| Legs are up here and stud in center.
good luck.
chuck
|