Aha, the word is legs.
Let's spread the word
LOL
Peter
----- Original Message -----
From: "chuck nicodemus" <armorseal@spiretech.com>
To: "Kevin McLemore" <kmclemore@hotmail.com>
Cc: <alpines@autox.team.net>
Sent: Monday, July 01, 2002 4:34 PM
Subject: Re: Intake Manifold for Series V (Zenith-Stromberg)
> Kevin McLemore wrote:
>
> > Hi, all..
> >
> > So, the question is:
> >
> > Does anyone out there have one of those cast clamps that secures the
#2-#3
> > intake ports to the motor?
> >
> > (To understand what I need, see the item listed as "Clamp D - PN
1214539" in
> > the picture here: http://www.team.net/www/rootes/rsb/68_18.html )
>
> Kevin, some times if you don't have one , this is real simple. get a
> small piece of channel iron the heavest you can find but less than 2"
> wide. cut it to lenght and drill the center hole out. This will take
> some time to fitt but a grinder and 3/8 drill will help the job be
> quicker. then set the bolt stud in and with the legs towards you put a
> good thick washer on and tighten it down.
>
> Wish I could draw, |__8__| Legs are up here and stud in center.
> good luck.
> chuck
|