Wilwood M/C

alpines

Wilwood M/C

To:	"alpines@autox.team.net" <alpines@autox.team.net>
Subject:	Wilwood M/C
From:	<ellis838@concentric.net>
Date:	Thu, 15 Feb 2001 08:13:00 -0500

Hello,
 Question, is the Wilwood master cylinder with the 3/4 inch bore big
enough to replace the stock 7/8 inch unit and not cause any braking
problems due to the different bore size. I want to use the Wilwood to
clear a set of side draft webers. Thanks Jim

[More with this subject...]

<Prev in Thread]	Current Thread	[Next in Thread>
Wilwood M/C, ellis838 <= Re: Wilwood M/C, jon Re: Wilwood M/C, Louis & Laila Re: Wilwood M/C, Greg Locke Re: Wilwood M/C, Barbara Blue Re: Wilwood M/C, Victor Hughes Wilwood M/C, Jay_Laifman RE: Wilwood M/C, Tom Hill RE: Wilwood M/C, Jay_Laifman RE: Wilwood M/C, Jay_Laifman

Previous by Date:	Re: Alpines on Film, Ian Spencer
Next by Date:	Re: Get Carter, Scott E. Christie
Previous by Thread:	Alpines on Film, Eddie Donovan
Next by Thread:	Re: Wilwood M/C, jon
Indexes:	[Date] [Thread] [Top] [All Lists]