Mr. Sloane did a pretty good job of describing it, but as they say, a
picture is worth a thousand words:
http://www.victoriabritish.com/icatalog/tc/full.aspx?Page=79 items 9 and
10, don't think your castellated nut was part of the set up, it must have
fallen off something else. Greg Lemon
--------------------------------------------------
From: "im sloane" <im_sloane@hotmail.com>
Sent: Friday, November 22, 2013 5:45 AM
To: "Dave" <dave@ranteer.com>; "Triumph 6 Pack" <6pack@autox.team.net>
Subject: Re: [6pack] heater control valve
> It's a little thingie with a hole thru it on the side, threaded inside,
> and a
> small bolt goes into the end, tightening up on the control wire. When the
> wire
> is out, nothing holds it into the valve lever.
> good luck.Sloane :)69 Six, 72 Spit
>
>> From: dave@ranteer.com
>> To: 6pack@autox.team.net
>> Date: Thu, 21 Nov 2013 22:29:53 -0600
>> Subject: [6pack] heater control valve
>>
>> was replacing the heater control valve (72 TR6) tonight, and ok - I will
>> admit it b I wasnbt paying close enough attention.
>>
>> apparently the little bolt/nut combination just drop right out when you
>> arenbt looking. I found a castle nut on the floor that looks the right
> size
>> b is that part of it? and what I will hope to find in the morning is a
> bolt
>> with a hole in it? that the wire goes through? a picture would be
>> really
>> helpful.
>
> ________________________________________
>
> 6pack@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe: http://autox.team.net/mailman/options/6pack/glemon@neb.rr.com
________________________________________
6pack@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/6pack/mharc@autox.team.net
|