It's a little thingie with a hole thru it on the side, threaded inside, and a
small bolt goes into the end, tightening up on the control wire. When the wire
is out, nothing holds it into the valve lever.
good luck.Sloane :)69 Six, 72 Spit
> From: dave@ranteer.com
> To: 6pack@autox.team.net
> Date: Thu, 21 Nov 2013 22:29:53 -0600
> Subject: [6pack] heater control valve
>
> was replacing the heater control valve (72 TR6) tonight, and ok - I will
> admit it b I wasnbt paying close enough attention.
>
> apparently the little bolt/nut combination just drop right out when you
> arenbt looking. I found a castle nut on the floor that looks the right
size
> b is that part of it? and what I will hope to find in the morning is a
bolt
> with a hole in it? that the wire goes through? a picture would be really
> helpful.
________________________________________
6pack@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/6pack/mharc@autox.team.net
|