was replacing the heater control valve (72 TR6) tonight, and ok - I will
admit it b I wasnbt paying close enough attention.
apparently the little bolt/nut combination just drop right out when you
arenbt looking. I found a castle nut on the floor that looks the right size
b is that part of it? and what I will hope to find in the morning is a bolt
with a hole in it? that the wire goes through? a picture would be really
helpful.
the moss motors catalogue and the shop manual I have are no help . . .
________________________________________
6pack@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/6pack/mharc@autox.team.net
|