Now that we figured that out, what is the effect of blocking the by-pass
valve and what is the best way to block it? Some use tin. Can't I just
make a gasket without the openings?
Bill
E-MAIL CONFIDENTIALITY NOTICE: The contents of this e-mail message and any
attachments are intended solely for the
addressee(s) and may contain confidential and/or legally privileged
information. If you are not the
intended recipient of this message or if this message has been addressed to
you in error, please
immediately alert the sender by reply e-mail and then delete this message and
any attachments. If you
are not the intended recipient, you are notified that any use, dissemination,
distribution, copying, or
storage of this message or any attachment is strictly prohibited.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|