Bob:
Nice little article, and spot on best I can tell.
The article fails to mention how difficult it is to access the adjuster
screw
on the rear carb. It is between the carbs and requires a screw driver of no
more than 2 inches in length.
I used a short finishing nail and filed a flat blade on the tip. I keep
it in
the tool chest in case I need to adjust the valves. Fortunately, once set up
they seem to never need any fiddling.
Vance
Vance Navarrette
Cogito Ergo Zoom
I think, therefore I go fast
-----Original Message-----
From: 6pack-bounces@autox.team.net [mailto:6pack-bounces@autox.team.net] On
Behalf Of Bob
Sent: Wednesday, September 09, 2009 11:22 AM
To: Couzelis,William M.; 6pack@autox.team.net
Subject: Re: [6pack] Effects of blocking bypass
This is the VTR article I found bypass valves, see second paragraph.
http://www.vtr.org/maintain/zs-tech-tips.shtml
Bob
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|