I would move all the plug wires one hole on the cap and try again to set the
timing..
----- Original Message -----
From: "Joe Laurito" <trglory@verizon.net>
To: "6Pack List" <6pack@autox.team.net>
Sent: Monday, August 31, 2009 8:43 PM
Subject: [6pack] TR6 Dizzy - Part 2
> As a follow-up, I made sure the car was running tip-top before I started
> the
> change-over. Car ran smooth as butter. Looked at the timing with a strobe
> and found it to be set at about 9 ticks BTDC (I assume that equates to 18
> degrees?) at idle which was about 750RPM and solid as a rock.
>
> Pulled the points and condenser and installed the Pertronix. I had to cut
> the wires back because they were way too long and the connectors were much
> too small for the mates on the coil. In addition, both red & black wires
> had
> female connectors and the coil wants a male on the negative side. I
> started
> the car up and it sounds like a blown exhaust gasket. It bangs, burps,
> backfires through the carbs and acts extremely rude on the whole. I did
> not
> move the distributor, but timing is now 2 ticks (4 degrees?) ATDC. I tried
> to retard the timing, but when cranked all the way clockwise, the best I
> can
> do is about 3 ticks BTDC so I returned it to where it was at two ticks
> ATDC.
> Idle is 500 RPM and very rough.
>
> I increased the idle speed to 800RPM and installed a new rotor, cap,
> ignition wires and nothing got any better (or worse). I changed to a
> Pertronix Flamethrower coil (which is larger than the Lucas and does not
> fit
> in the coil bracket) and nothing got any better.
>
> Not sure what to do next....put the points back?
>
> Joe
>
> -----Original Message-----
> From: 6pack-bounces@autox.team.net [mailto:6pack-bounces@autox.team.net]
> On
> Behalf Of Joe Laurito
> Sent: Monday, August 31, 2009 11:10 AM
> To: 6Pack List
> Subject: [6pack] TR6 Dizzy
>
> I'm getting ready to install a Pertronix unit in the distributor of my '75
> TR6. The current circuit has a red and a white wire from the harness going
> to the plus side of the coil and a black wire coming off the plus side of
> the coil going to a blue can (capacitor?) that is grounded to the coil
> mounting bolt. That last item is not shown on the wiring diagram
> applicable
> to that year. When I mount the Pertronix, should I keep or remove the blue
> component?
>
> Joe
> _______________________________________________
> _______________________________________________
>
> Support Team.Net http://www.team.net/donate.html
>
> 6pack@autox.team.net
> http://autox.team.net/mailman/listinfo/6pack
>
> http://www.team.net/archive
>
> You are subscribed as rmcbride@mi.rr.com
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.409 / Virus Database: 270.13.73/2338 - Release Date: 08/31/09
17:52:00
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|