I haven't had to resort to this personally but I know people that have. I
think that if you are just stabbing it with a mig welder a few times to sick
the nut to the plug it would be no worse than heating up the plug with mapp
gas.
Stan
-----Original Message-----
From: Navarrette, Vance [mailto:vance.navarrette@intel.com]
Sent: Wednesday, September 10, 2008 10:21 AM
To: Foster, Stan; 6pack@autox.team.net
Subject: RE: [6pack] Removing gearbox fill plug
Stan:
Is this approach safe? The casing is aluminum, and I would be afraid
of damage by that much heat. I suppose a mig might be OK (as opposed to
acetylene) as it minimizes the amount of heat applied, but I would still
worry. Have you tried this before on an aluminum casing? I have not, so if you
have and it worked, then I humbly withdraw my concern...
Vance
Vance Navarrette
Cogito Ergo Zoom
I think, therefore I go fast
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|