Stan:
Is this approach safe? The casing is aluminum, and I would be afraid
of damage by that much heat. I suppose a mig might be OK (as opposed to
acetylene) as it minimizes the amount of heat applied, but I would still
worry. Have you tried this before on an aluminum casing? I have not, so if you
have and it worked, then I humbly withdraw my concern...
Vance
Vance Navarrette
Cogito Ergo Zoom
I think, therefore I go fast
-----Original Message-----
From: 6pack-bounces+vance.navarrette=intel.com@autox.team.net
[mailto:6pack-bounces+vance.navarrette=intel.com@autox.team.net] On Behalf Of
Foster, Stan
Sent: Wednesday, September 10, 2008 6:37 AM
To: 6pack@autox.team.net
Subject: Re: [6pack] Removing gearbox fill plug
John, a common measure of last resort is to weld a large hex nut on the end
of
the plug so you can get a proper wrench on it. Do this before you weaken that
plug any further.
Stan
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|