The book says:
Screw the strainer into the pump body plate until the measurement between the
pump body face and the end of the strainer gauze is 4.25 inches.
Stan
-----Original Message-----
From: 6pack-bounces+stan.foster=hp.com@autox.team.net
[mailto:6pack-bounces+stan.foster=hp.com@autox.team.net] On Behalf Of
osternd@copper.net
Sent: Thursday, September 04, 2008 1:07 PM
To: 6pack@autox.team.net
Subject: [6pack] seeking easy TR6 windage tray & oil baffle design
Speaking of oil starvation - I had problems with my "professionally" rebuilt
motor several years ago. I have a steep driveway, and if the oil level was a
little low, I would lose oil pressure when I reached the top of the driveway.
Turns out the oil pick-up had not been adjusted and was screwed fully into the
pump. After adjusting it such that it sat lower in the sump, I never had any
more problems with it. Fortunately there was no engine damage, so I guess I
dodged a bullet there.
I've never seen any recommendations on adjusting the pick-up, but it made a
huge difference for me by setting it as low in the sump as possible. Something
worth looking at when assembling your motor -
Dale
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|