Bob---I don't think one can over-pack this area. Still, there's no need to have
excess. So I just brush the molygrease on and into the male splined half, and
using the same stiff brush, reach into the female side as far as possible, to
paint around these splines. There will be some excess, pushed back into the
recess, as well as some squeezing to the outside. Not much heat generated in
this area, so what grease is applied should stay put.
Dick
-----Original Message-----
From: Bob Danielson
Sent: Tuesday, September 2, 2008 4:56 PM
To: triumphs@autox.team.net, 6pack@autox.team.net
Subject: [6pack] Axle Grease - How Much to Use?
Folks.....when reassembling the two halves of a TR6 axle, how much grease do
you pack in there? Do you just coat the splines or do you pack it in so that
a bunch squishes out when you press the two halves together?
Thanks
Bob
Bob Danielson
1975 TR6 CF38503U
Running w/ Throttle Body Injection
Toyota 5 Speed & Nissan LSD
<http://tr6.danielsonfamily.org/> http://tr6.danielsonfamily.org
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
You are subscribed as tr6taylor@webtv.net
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|