Hi Kendall
It is a very good time to get a photos to you as I have the motor out right
now. I built a higher compression motor this winter and it is going in this
weekend. I will get you some photos of the conversion parts including the
o2 sensors.
Calvin
-----Original Message-----
From: Kendall Larsen [mailto:mailkendall@sbcglobal.net]
Sent: Friday, March 28, 2008 3:41 PM
To: Calvin Allen
Subject: Re: [6pack] 02 sensor locations
Hi Calvin,
Interesting! Do you have any pictures?
Kendall
----- Original Message ----
From: Calvin Allen <callen@molycop.ca>
To: Triumph 6 Pack <6pack@autox.team.net>
Sent: Friday, March 28, 2008 3:31:26 PM
Subject: Re: [6pack] 02 sensor locations
I have a TR6 with a standard exhaust manifold. I drilled two holes in the
manifold(One in Each Bank) to mount O2 sensors. I have run the car for 1
year without any concerns. I thought the manifold might crack, however no
problems or leaks. I have the TBI conversion running with a megasquirt ecm.
73TR6
Calvin
Subject: [6pack] 02 sensor locations
Where is the best place to locate sensors... Nelson Reidell suggests in the
middle of the down pipes. I have the 76 double pipe system, so I guess I
need two sensors and a switch to get readings off both carbs. Any
suggestions or advice?
_______________________________________________
Support Team.Net http://www.team.net/donate.html
6pack@autox.team.net
http://autox.team.net/mailman/listinfo/6pack
http://www.team.net/archive
|