On Mon, 22 Oct 2007, Greg Perry wrote:
> Rick,
>
> The lower control arm needs to be vertical with respect to the ground.
> This will give you access to the inner nuts. With the weight of the car
> supported with a jack stands on the frame, I use a section of 2" x 4" to
> support the control arm under the trunnion so that the arm is about
> vertical. Greg Perry
I sure hope you meant to say "horizontal", not vertical.
>> Q2 -
regards,
rml
---------------------------------------------------------------------------
Bob Lang Room N42-140Q | This space for rent
Consultant MIT IS&T unix-linux-help |
Voice:617-253-7438 FAX: 617-258-9535 | Cell: 339-927-4489
---------------------------------------------------------------------------
|