Not sure if this will work on these keys, but just recently I had to
have my TR3s generator worked on, the guy took the woodruff key,
placed it on a vise/anvil (flat side up/down) and gave it a whack
with a BFH ... then he just casually put it all back together with no
problem ...
> Vic:
>
> You should not need to use a press. I suggest polishing the
>woodruff keys with some 600 grit sandpaper, polishing each side
>until it is smooth and shiny. Place the paper on a flat surface
>and press down on the key while moving it in a figure 8. Don't
>over do it.
>
--
Bill Pugh
1957 TR3 TS16765L
aka
Casper
1970 TR6 CC59179L
aka
Rosey
Wallace, CA
|