To: | 6pack@autox.team.net |
---|---|
Subject: | Grose jets |
From: | DaCRANEz@aol.com |
Date: | Sun, 15 May 2005 11:34:43 EDT |
I installed Grose jets and noticed that they came with a thin fibre washer rather than the thick aluminum washer used on the stock needle valves. I set the floats to factory specs. Now have an exceedling rich idle. Should I reset floats a little lower or install the thicker washers? I haven't been able to lean up the carbs enough to compensate. TIA Mike C '71 TR6 |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Bonnet Release, Dennis N Culligan |
---|---|
Next by Date: | Doin' it today!, John & Allison Cyganowski |
Previous by Thread: | Clunk, yet again..., Bob Rochlin |
Next by Thread: | RE: Grose jets, Navarrette, Vance |
Indexes: | [Date] [Thread] [Top] [All Lists] |