Hi Mark,
What did you do about the bolts -- TRF supply them? Yes, Moss describes it as
being square. I'll
check mine.
Thanks,
Don Malling
Mark Riddle wrote:
> Don,
> I redid my calipers per Nelson's write-up, and I used a kit from TRF. It
> contained the "seal" for the caliper halves. The original seal was not an
> O-ring, but a square profile.
> I torqued per Nelson's recommendation, and have had no problems for a two
> year period.
> I blasted the calipers, but would caution you to be very thorough on the
> recess for the piston seal. There tends to be an accumulation of rust in
> the deep corners of the "recess", that blasting was not totally removed
> by the media. I very carefully used a blade to remove the remaining
> corrosion, and as I said before, no problems.
>
> Hope this is helpful,
>
> Mark Riddle
> 72' TR6
|