> "largely a poseur racing upgrade."
>
> Well put Kai. Is it possible to manufacture vented rotors (the
> sandwich kind that is common on most every automobile) that
> still fit the stock TR6 calipers?
>
> Rick O.
Yes, Rick there is. There is an off the shelf vented rotor that fits, I
want to say Toyota Creseda (early 1980s)... but you'll have to check Roger
William's book (I admit there are _a few) bits of good information in it)...
the example in the book uses the stock TR6 calipers, but sandwiches a 10mm
or 11mm piece of aluminum in between the caliper halves to compensate for
the larger rotor.
Hope that helps...
Kai
--
Kai M. Radicke
Wishbone Classics
www.wbclassics.com
Ph: 215.945.7250
|