Re: fan belt

[Cregg Cowan <cowan@erg.sri.com>]

Hi Scot,

I had a similar problem until I replaced the engine and transmission mounts.
Until then, a jack and block of wood under the engine should provide just 
enough room
to allow you to get the belt past the crossmember.

Be careful not to move the engine too much unless you also remove the 
radiator hoses.  Otherwise you run a risk of cracking the solder where each 
neck(?) is connected to the radiator.  I cracked mine while changing engine 
mounts :-(

Good Luck!
Cregg Cowan
CC63129L