The kit includes 8 rubber bushings, 10 washers, two off set L- brackets, two
L- brackets, four bolts and 4 Ny- lock nuts. 4 pipe clamps. Then of course
two pipes with resonators and two end mufflers.
You will need to hold on to the down pipe fixed to the exhaust manifold and
the first two pipes from there.
The two off set L-brackets get bolted to the rear differential rubber mounts
on the outer side of the large washer. Use an additional small washer for
good measure. Point the small part to the rear wheel and align parallel. The
second L bracket gets mounted to the frame. The last bolt through the frame
that holds the body to the frame is the one that is used. USE LOTS OF ANTI
SEIZE. Then mount your resonator pipes making them run along the frame. The
muffler then gets mounted with the mounting brackets towards the frames. Use
the rubber bushings on both sets of L brackets. Once all is aligned and
making sure its not touching the cross member, tighten everything down and
apply and tighten the pipe clamps.
Hope this helps.
Robert not "Bob" Gannon
http://hometown.aol.com/twodzusfittings/myhomepage/auto.html
/// 6pack@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|