Re: Outer Hub U joints

[Mark J Bradakis <mjb@autox.team.net>]

>  My only mistake was putting the same thread (5/16-28 or NF) back in instead
>  of the better NC style (sure hope I remembered the thread pitch right)

What is your reasoning for preferring coarse threaded fasteners?  A fine
threaded fastener will be stronger and provide better torque locking than
a course thread of the same outer diameter.

mjb.

///  6pack@autox.team.net mailing list
///  or try  http://www.team.net/cgi-bin/majorcool
///  Archives at http://www.team.net/archive