Maybe try a Gunst?
http://www.buckeyetriumphs.org/technical/Clutch/ReliableClutch/ReliableClutch.htm
Does anyone know if the Gunst bearing works with both B&B's -- straight
fingers or bent fingers?
I will ask Joachim Gunst as well. He is on vacation this week.
Don
Todd Bermudez wrote:
> Interestingly enough,
>
> I recently put the gearbox(j-type tranny), that was in my tr250 into my tr6,
> which i'm very happy to report that tomorrow, I BUY PLATES!
>
> Anyway, I put a brand new b&b clutch in, but I used my old t/o bearing. The
> clutch in my TR250 had "flat" fingers(older b&b unit) & the t/o bearing
> didn't squeal. Well the new clutch has fingers that are "bent". It
> squeals...of course this makes me very happy:(((
>
> Don't care, I'm gonna run what i brung & hope I brung enough!
>
> Todd Bermudez
> '68TR250(under major construction)
> '74TR6...down the road baby!
>
>
>
>>From: Pat Leask <pleask@shaw.ca>
>>Reply-To: Pat Leask <pleask@shaw.ca>
>>To: 6pack@autox.team.net
>>Subject: What T/O bearing for TR6 ?
>>Date: Sun, 01 Jun 2003 19:35:47 -0700
>>
>>After only 400 miles on my TVR (TR 6 motor and trans) once again a brand
>>new Borg n Beck T/O bearing is squealing !! ARG.. no more said.
>>
>>I'm told that the RHP bearing is supposed to be better, I'm wondering what
>>experiences any of you have had. I figure if my TVR eats these things yours
>>must too !
>>
>>I'm afraid that a Magic Clutch is not in the cards as I have a new Borg n
>>Beck clutch, I also heard there was problems with them.
>>
>>Thanks, Pat
>>PS: PLEASE reply to my email address of pleask@shaw.ca so as to not bomb
>>the group.
>
>
> _________________________________________________________________
> STOP MORE SPAM with the new MSN 8 and get 2 months FREE*
|