Interestingly enough,
I recently put the gearbox(j-type tranny), that was in my tr250 into my tr6,
which i'm very happy to report that tomorrow, I BUY PLATES!
Anyway, I put a brand new b&b clutch in, but I used my old t/o bearing. The
clutch in my TR250 had "flat" fingers(older b&b unit) & the t/o bearing
didn't squeal. Well the new clutch has fingers that are "bent". It
squeals...of course this makes me very happy:(((
Don't care, I'm gonna run what i brung & hope I brung enough!
Todd Bermudez
'68TR250(under major construction)
'74TR6...down the road baby!
>From: Pat Leask <pleask@shaw.ca>
>Reply-To: Pat Leask <pleask@shaw.ca>
>To: 6pack@autox.team.net
>Subject: What T/O bearing for TR6 ?
>Date: Sun, 01 Jun 2003 19:35:47 -0700
>
>After only 400 miles on my TVR (TR 6 motor and trans) once again a brand
>new Borg n Beck T/O bearing is squealing !! ARG.. no more said.
>
>I'm told that the RHP bearing is supposed to be better, I'm wondering what
>experiences any of you have had. I figure if my TVR eats these things yours
>must too !
>
>I'm afraid that a Magic Clutch is not in the cards as I have a new Borg n
>Beck clutch, I also heard there was problems with them.
>
>Thanks, Pat
>PS: PLEASE reply to my email address of pleask@shaw.ca so as to not bomb
>the group.
_________________________________________________________________
STOP MORE SPAM with the new MSN 8 and get 2 months FREE*
|