To: | "6pack \(E-mail\)" <6pack@autox.team.net> |
---|---|
Subject: | Rear crank seal |
From: | "Cliff Davies" <cdavies@holzher.com> |
Date: | Tue, 22 Apr 2003 15:03:36 -0400 |
In the Comp Prep Manual there is mention of installing the rear crank seal assembly back to the block using a special tool to line it up. This is the only place I have ever heard mention of this. Can anyone tell me if this is critical? Same deal on the distributor end float it is in Bentley's, I have never seen a post on this subject either. I bet a gasket is put down dizzy attached and away we go. Just curious. Thanks, Cliff |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: An almost disasterous moment..valves, Skip Montanaro |
---|---|
Next by Date: | Re: How do you remove glass from tach bezel?, Sally or Dick Taylor |
Previous by Thread: | carb rebuild - redux, R. Ashford Little II |
Next by Thread: | Re: Rear crank seal, Robert M. Lang |
Indexes: | [Date] [Thread] [Top] [All Lists] |