Richard,
Thanks...
I was just about to go take some pictures, and give a little gearbox
seminar... :-)
Best regards,
Jim Swarthout
-----Original Message-----
Cc: Gary Fluke; Jim Swarthout; TR6 list
Subject: Re: Shifting
The TR6 trans is constant mesh. The only gear that moves in and out of
mesh
is reverse. The gear on the input shaft meshes with a gear on the
countershaft driving the countershaft. Other gears on the countershaft
mesh
with and drive first, second and third gears which reside on bushings on
the mainshaft. All of them turn all of the time but since they are
different sizes, they turn at different speeds. When shifting through
the
four gears you are not moving gears but synchro hubs which engage the
chosen gear to the main shaft to drive the mainshaft (output shaft) at
the
speed of the chosen gear. In fouth gear the mainshaft is engaged
directly
to the input shaft (1 to 1 ratio).
Richard Good
Sally or Dick Taylor wrote:
> Gary---Thanks for the briefing on the "non-constant mesh" feature of
> (for one) the TR6 transmission. Other than replacing an end bearing,
> seals, and shifter O-rings, there is a lot I don't know about
> transmissions. However, I was surprised at Swarthout's description of
> what he felt was happening here.
>
> Eventually I'll have to find out how this all happens myself, as the
> miles rolled past three hundred thou., and major work here is
imminent.
> First, I have to see if the recently rebuilt differential is going to
> stay together, without protest! Also, thanks here to Berry and Bob
for
> sharing some of their experience in this matter.
>
> Dick
|