On Thu, 26 Dec 2002, Robert L. Gannon wrote:
> Question for the List.
Ready...
> Problem: I need to raise the rear height of the TR6 due to the
> scraping of the muffler system on the entrance to my driveway. Also I
> am always scraping those irritating speed bumps.
Hmmm. What part of the muffler system is dragging? Your solution could be
as simple as rotating the clamps for additional clearance!
> Question: Do those cast Aluminum spacers that sit between the top of
> the spring and the upper rear cross member really raise the height of
> the car? Anyone have that set up? Does it change the handling of the
> car?
Well, first off, the alley spacers that I've used for the last number of
years are not cast, they are machined and stackable. You are also better
served to place the spacers _under_ the springs! If you put them above the
springs, they can fall out. Don't ask how I know this.
:-)
The spacers will raise the car. The amount of height increase is roughly
1.5 X the thickness of the spacer, so a 1/2" spacer will raise the car
about 3/7 of an inch.
Be aware, however, that this change in height also changes the rear camber
setting. If you add the spacers, you _may_ need to play with the swivel
brackets to get the camber "just so". This is no big deal, but you need to
be aware of it.
> Robert L. Gannon
> trsix74@comcast.net
> TR6 1974 CF22956U
> TR3A 1960 TS70951L
> http://hometown.aol.com/twodzusfittings/myhomepage/auto.html
regards,
rml
------------------------------------------------------------------------------
Bob Lang Room N42-140Q | This space for rent
Consultant MIT unix-vms-help |
Voice:617-253-7438 FAX: 617-258-9535 |
------------------------------------------------------------------------------
|