Don,
The brake lines are very easy to bend by hand. Use the old brake line
as a guide to bend the new brake line. I usually do this on the floor
comparing the two brake lines as I form the new one. For tight bends
use a broom stick or round pipe as a guide.
As for the 4 piece clutch kit, the kit usually contains the pressure
plate, disk, throwout bearing and a clutch alignment tool. Some times
you can use a broom stick or 1"' x 1" (or appropriate size) soft pine
stake as the clutch alignment tool. Of course you might have to whittle
it a bit to fit.
Greg Perry
Don Malling wrote:
>List,
>
>I plan to replace all the brake lines on my TR250. TRF sells unbent
>pipes. Is there any tool(s) I need to bend the pipes?
>
>Is bending the pipes difficult, and if so can anyone suggest a source
>for pre-bent pipes?
>
>Thanks,
>
>Don Malling
|