Bob,
If you want the air bubbles out...Get yourself a sewing needle and puncture
a tiny hole and you will get the bubblesout. As far as the creases go...I
don't think there is a remedy for that.
Good luck,
Patrick
-----Original Message-----
From: owner-6pack@autox.team.net [mailto:owner-6pack@autox.team.net]On
Behalf Of RedTriumphTr6@aol.com
Sent: April 1, 2002 5:17 PM
To: 6pack@autox.team.net
Subject: application of emissions decal/label on fender under the bonnet
Do any of you know how to best apply the emissions label which has the
timing
and dwell and idle cam adjustment data and diagrams on the driver side
inside
fender? I bought one replacement and it did not apply smoothly...far too
many creases and air bubbles remained.. what did I do wrong? For the life
of me I could not press out all the wrinkles when I carefully applied over
the top of the old label. This is a dry transfer, not a water based decal.
Thanks. Bob Pierson
74 1/2
|