Strangely I have only two rivet holes on the top inside fender on the
drivers'side(LHD). I bought the car in 1986 and it was like that. I always
assumed it was some sort of metal nameplate that went there. The chassis ID
is on a silver metal strip riveted to the firewall on the right-hand side.
So what is supposed to go on top of the left wheel arch of a 1972 TR6
cc83453O ?
Mark Hooper
-----Original Message-----
From: RedTriumphTr6@aol.com
To: 6pack@autox.team.net
Sent: 01/04/02 5:17 PM
Subject: application of emissions decal/label on fender under the bonnet
Do any of you know how to best apply the emissions label which has the
timing
and dwell and idle cam adjustment data and diagrams on the driver side
inside
fender? I bought one replacement and it did not apply smoothly...far
too
many creases and air bubbles remained.. what did I do wrong? For the
life
of me I could not press out all the wrinkles when I carefully applied
over
the top of the old label. This is a dry transfer, not a water based
decal.
Thanks. Bob Pierson
74 1/2
|