I replaced the two small orings that go on the shaft from a local hydraulic
shop. They had the exact size oring and stated they were designed for hydraulic
fluid, but for silicon base. They are called BUNA type orings. Since I am
using Silicon fluid should work ok. He didn't have any designed for DOT3 or 4.
I ended up buying about thirty of the buggers in case they hold. If they work
I am more than happy to ship some to folks for the cost of shipping. I'll keep
you posted.
Jim
75 TR6
80 TR7
Kissimmee, FL
Date: Tue, 27 Nov 2001 08:43:42 -0500
From: "Riddle, Mark"
<riddlem@ciitech.com>http://pages.prodigy.net/jdhenn/pdwa1.jpg
Subject: PDWA repair kit
Listers,
A few days ago there was a discussion of the PDWA, and its repair. I did not
make a note of the information about available repair kits. I did look at
the link below, and checked my unit, and found that it was indeed the very
same "brass" unit, with identical plunger.
My question is, what was the consensus about repair kits for this version?
Sorry to bring it up again, I should have paid attention the first time.
TIA
Mark Riddle
'72 freshly painted "Damson", soon to be reassembled TR6
|
