Richard,
DON"T cut the body in half!!!!! Is the body off the car yet? The rocker and
floors can be replaced properly with the body on frame. If the gaps are good
you can weld a brace from the frt a post to the rear b post and remove the
doors, then the body will not flex. This type of work should be done by an
experience welder. If you don't fit into that range, leave it for someone
who is. Rockers are bad enough, but to do the floors also, it's not a small
job. You'll need a MIG welder, Plasma cutter and a lot of skill to do a safe
job. Just my 2 cents.
Jim Holewka
1969 TR6
1972 TR6
1980 TR7
1980 TR7-V8
New Jersey
In a message dated 10/16/01 7:49:49 PM, RSH17@msn.com writes:
<< Should I cut the body in half since both rockers
and floors will be replaced and it will make removal of the body easier, but
how about aligning everything up again. >>
|