Problems with setting the dwell

["John Phillips" <TR6@vigoris.net>]

John H.

This is really off the wall but I actually found this on a car I recently
worked on.  The bottom breaker plate was upside down.  Believe me, that will
really make it hard to set the dwell.  The bottom plate should nest into the
upper plate via the flare at the center hole.

By the way, anyone know where to buy a new bottom breaker plate?


John Phillips, Claremore, OK
Green Country Triumphs & Jaguar Enthusiasts Club
76 TR6 CF51655   74 TR6 CF 15694
89 XJS Convertible
 http://www.greencountrytriumphs.com/