> From: Brad . [mailto:brad1184@hotmail.com]
> Sent: Friday, April 27, 2001 5:26 PM
>
> I am in the process of overhauling my master cylinder
> and i am stuck at a point. My manual says to remove
> the tipping valve by pushing in the cylinder, then all it says
> it to remove the tipping valve. I have no clue how to
> remove that so your input would be great.
Brad, I think if I recall correctly that you have to undo a large allen head
nut which keeps the tipping valve in the MC body. In order to do this you
need a 1/2" allen key (or equivalent). I've heard of people using a 1/2"
head bolt gripped with lockjaw pliers. Personally I used a 1/2" allen key
which I obtained from a local fastener shop. (This is a large size and might
not be available from the local Sears, Home Depot, etc).
HTH.
Peter Zaborski (CF58310 UO)
|