Peter,
I replaced these seals as part of the ongoing interior work in my '72
TR6.
I did see a picture or drawing of the tool you mentioned, I actually
built one (well, actually banged one into shape), from a piece of flat
stock (steel).
In order to install, I cut the waist seal to the proper length. I
then held the seal in place and "pulled" the clip into position. I
was a real p*&( in the a^^. This took a while, and while the results
are passable, it's one of those things that I'll probabl;y go back and
fiddle with in the future.
Good Luck,
Bill
|