Re: TR4 Engine Rear Main Seal

[R John Lye <rjl6n@uva.pcmail.virginia.edu>]

On May 28,  7:19pm, John Wroclawski wrote:

> The easiest way to get the mandrel is to have your friendly local machinist
> make one for you, or do it yourself if you have access to an accurate metal
> lathe. If I remember right the dimensions are in the factory (== Bentley)
> shop manual. If not, holler and I'll see if I can dig them up for you...

Actually, Moss Motors has these for sale - they've made them out
of nylon or Delrin, and they aren't that expensive as I recall.
I've got one sitting in my toolbox, but haven't used it yet.

later,


John Lye

rjl6n@uva.pcmail.Virginia.EDU