[Spridgets] little valve o-rings

["Mark Haynes" <haynes386@netzero.net>]

So I'm assembling the 12G295 head now that its been milled. The little bugger
o-rings on the factory exhaust valves are a pain, I can't get the valve
retainers into place with them there. Can I just do without them without
hurting anything? It seems to me that they were there to quiet the valve
train. Granted, it allows the valve springs to be slightly more extended in
the closed position, but due to the constant extension load they shouldn't
move at all. Any thoughts?


Mark Haynes
It only goes one way-Pay it Forward
HAN6L12977
HAN5L8016

____________________________________________________________
Groupon&#8482 Official Site
1 ridiculously huge coupon a day. Get 50-90% off your city's best!
http://thirdpartyoffers.netzero.net/TGL3231/4dd1330d686b74aca27st01duc
_______________________________________________

Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums