http://cgi.ebay.com/9-16-SQUARE-WRENCHES-MADE-U-S-A-4PC-LOT-/150564022179?pt
=LH_DefaultDomain_0&hash=item230e50a7a3
These should work. An alternative is to buy a long open end wrench and weld
a plate across the open end to keep it from spreading. Use a length of pipe
on the wrench to give you leverage. Another solution is to use a pipe wrench
and buy a replacement plug from your Nissan dealer if the old one is too bad
to use again.
Put a little anti-seize compound on the threads when you replace the plug. -
Jim
-----Original Message-----
From: spridgets-bounces at autox.team.net
Hello,
bought a long 14 mm wrench today, got under the car and banged
with a hammer on it and still can't budge the fill plug.
Someone suggested warming it with a 100 watt light bulb...
would driving the car and warming the tranny do the same thing,
seeing as how I don't have a drop light? .. or should I get one
of those too?.... (mine is a cordless LED type, no heat)... or
how about a blow dryer aimed at the plug?...
--
Best regards,
Bill L.
_______________________________________________
|