Hello Spridgets,
I've been trying to get the FILL plug out of the side of my DATSUN
tranny. I haven't tried the drain plug yet. Anyway, it's in so tight
I can't budge it. I tried a 9/16" end wrench to no avail, then a 12"
crescent, then I banged lightly with a hammer on the end of the
crescent. .. Is the fill plug left hand thread? How much pressure
should I be willing to put on the thing? What size 12 point socket
fits a 14 mm square? Could it be galled up?
--
Best regards,
Bill L. mailto:pythias@pacifier.com
'66 Sprite MKIII HAN8L49403 "the red thing"
When tempted to fight fire with fire, remember that the Fire Department
usually uses water.
_______________________________________________
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|