As quoted below - I've found where the vacuum take off is (I hope!)
The Morris Minor 1000 workshop manual text refers to a "ignition control pipe"
fitted to the carburettor - but it does not give any details, drawing or part
number.
No mention at all in the Haynes Sprite manuals!?
I'm assuming it is a small diameter cooper tube that is threaded on one end to
screw into the carburettor.
It is a 948cc engine with a single HS SU carburettor.
Does anyone have a scrap HS carb that they could take the copper(?) pipe off
and sell it to me? I'm also guessing that it's probably about 1" -> 1.5" long.
Or what the thread might be...
No supplier lists it ;-(
--
Dave G KK7SS
DN06ig
,59 Morris Minor 1000
'65 Sprite - in process
'76 Midget - shared with my #4 son.
'06 Honda Civic Hybrid
----- "Dave KK7SS" <kk7ss@frontier.com> wrote:
> There *is* a threaded hole, with nothing in it, just below the
> throttle shaft and on the engine side of the butterfly.
> This should be the vacuum take-off point, Yes?
>
> I believe I can see a small brass plug with a small orifice in it at
> the bottom of this hole.
> So whatever was fitted there, isn't there anymore ;-(
>
> Where can I get whatever fits in that hole???
> Has anyone got a spare one?
>
> It was the "threaded hole" clue Bruce that did it ;-)
_______________________________________________
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|