[Spridgets] Thrust washers ahd crankshaft end float

[soavero at yahoo.com (Ron Soave)]

--- On Sat, 2/19/11, Leo <60bugeye at cebridge.net> wrote:
> cranks I brought him this afternoon.  The thrust
> washers themselves measure
> .092  .. 

I just measured 12 different thrust washers, AE, ACL and Vandervell, all 
measured .092. BUT...the packages were labeled "Standard", so over-sized ones 
exist. Try Rod at Spridgetech.com. Personally, I have almost always have too 
little end float and have to take a bit off the washers. Something ain't right.

Ron