spridgets
[Top] [All Lists]

Re: [Spridgets] Thrust washers ahd crankshaft end float

To: bugeye@yahoogroups.com, spridgets@autox.team.net, Leo
Subject: Re: [Spridgets] Thrust washers ahd crankshaft end float
From: Ron Soave <soavero@yahoo.com>
Date: Sat, 19 Feb 2011 18:52:33 -0800 (PST)
--- On Sat, 2/19/11, Leo <60bugeye@cebridge.net> wrote:
> cranks I brought him this afternoon.  The thrust
> washers themselves measure
> .092  .. 

I just measured 12 different thrust washers, AE, ACL and Vandervell, all 
measured .092. BUT...the packages were labeled "Standard", so over-sized ones 
exist. Try Rod at Spridgetech.com. Personally, I have almost always have too 
little end float and have to take a bit off the washers. Something ain't right.

Ron
_______________________________________________

Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>