Thanks for all the helpful suggestions so far. Let me however, restate my
question another way:
I am currently having a 1275 rebuilt. This is for a street Bugeye driven
spiritedly. We'll probably go .020 or .030 over, Kent 274 cam, 1.5 rockers and
twin HS4 SU's. I am now looking for recommendations on a suitable header. The
exhaust pipe and rear muffler, I'll figure out from there.
Thanks all,
Howard Collins
-----Original Message-----
From: Robert E. Shlafer <pilotrob at msn.com>
To: midgetsprite at yahoogroups.com; spridgets at autox.team.net
Sent: Thu, Jan 13, 2011 7:31 am
Subject: Re: [Spridgets] [midgetsprite] Exhaust Pipe Recommendation Needed
For a stock street machine, the VB stuff is adequate however, if a "tuned"
pplication, I'd make the investment and go with the performance quality stuff
vailable at APT.
Refer to Vizard's book for correct header sizing (pipe diameter) based on
state
f engine tune.
CB
----Original Message-----
rom: miniac7 at aol.com
ent: Wednesday, January 12, 2011 7:52 PM
o: spridgets at autox.team.net, midgetsprite at yahoogroups.com
ubject: [midgetsprite] Exhaust Pipe Recommendation Needed
For a 1293 or 1310 rebuild going into a Bugeye, I'm about to order a Pace
etter header and a Monza free flow muffler from VB. I would like to know
hich exhaust pipe to order to go between these two components. There's a
umber of choices in their catalog, so a little help will go a long way before
talk to them.
hank you,
oward Collins
irginia Beach, VA.
Non-text portions of this message have been removed]
uggested annual donation $12.75
rchive: http://www.team.net/archive
orums: http://www.team.net/forums
nsubscribe/Manage:
http://autox.team.net/mailman/options/spridgets/miniac7 at aol.com
|