Bradster,
If that fails, the final resort is the old standard BMF hammer. ;-)
Cheers!!
Jim
On Sun, Apr 12, 2009 at 2:54 PM, Frank <spritenut@comcast.net> wrote:
> Brad Fornal wrote:
>
>> Frank, please, any suggestions on getting this thing apart? I've tried a
>> shot filled plastic mallet on the bell, slight prying in the bell ears (I
>> don't wish to break them off) and slight prying upwards on the piston, via
>> the carb throat.
>> What else might work?
>>
>>
>>
> A torch, heat it up pretty good and try to pry it.
> The aluminum has corroded itself together, heat it, don't melt it.
>
> -
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|