I could maybe take some digital pics when the sun comes up if that would
help?
1960 Bugeye
----- Original Message -----
From: "Frank" <spritenut@comcast.net>
To: "Jim F." <jimndi@frontiernet.net>
Cc: "Spridgets" <spridgets@autox.team.net>
Sent: Monday, March 09, 2009 10:00 PM
Subject: Re: [Spridgets] measurement needed (Bugeye)
> Jim F. wrote:
>> Well it just needs to be wide enough to carry the locking pins, right?
>> put the two rods together with a little grease on them, and thats your
>> width.
>>
> If I had one here to look at, I could figure out something.
> When there is nothing there, it's just a bit tough.
> I think I have to look at a decent bonnet in person as I think mine is
> missing too many parts down there.
> Locating pegs, where did they go?
> Holes for the twist latch, what holes, there is no metal there.
>
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.0.237 / Virus Database: 270.11.9/1991 - Release Date: 03/09/09
07:14:00
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|