Frank
Just ran out and checked mine. It appears to be 1 3/4 in the center and
tapers down to 1 1/2 at each end. I assume your talking about the channel
that the locking pins ride in? IDo you need the exact length as well?
Jim F
.
1960 Bugeye
----- Original Message -----
From: "Frank" <spritenut@comcast.net>
To: "Spridgets" <spridgets@autox.team.net>
Sent: Monday, March 09, 2009 5:48 PM
Subject: [Spridgets] measurement needed (Bugeye)
>I just got the bonnet for my daughter's Bugeye back from the blast shop,
> the channel where the latch handle goes is not there.
> Can someone please open their bugeye nose and give me the measurements
> (height, width) of that channel.
> The chrome latch handle goes through it, it is as wide as the radiator
> opening but since mine is gone, I have nothing to go by except spots
> where it used to be welded to the lower lip of the bonnet.
> Thanks.
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as jimndi@frontiernet.net
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.0.237 / Virus Database: 270.11.9/1991 - Release Date: 03/09/09
07:14:00
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|