What is the angle of the flare? A few years ago I had to buy a special 37
degree flareing tool for an stainless fittings. Isn't a standard
Brake/Clutch slave etc. a 45 degree double flare?
1960 Bugeye
----- Original Message -----
From: "Peter Caldwell" <peter@nosimport.com>
To: "Dean Swanson" <d.swanson@earthlink.net>; <spridgets@autox.team.net>
Sent: Friday, March 06, 2009 10:38 AM
Subject: Re: [Spridgets] Clutch Line Flare Type (was Clutch Slave Cylinder)
> Single or bubble flare with 3/8"-24 nut on a 3/16 line.
> Peter
> ==
> At 05:23 PM 3/5/2009, Dean Swanson wrote:
>>Well it appears that my leaky new slave cylinder is due to either the
>>collapse or separation of the actual flare on the end of the rigid clutch
>>pipe; so does anyone know what the proper flare type is so I can get it
>>flared again?
>>
>>
>>
>>Dean Swanson
>>
>>'62 A.H. Sprite mkII (that one day may see the road again)
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as jimndi@frontiernet.net
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.0.237 / Virus Database: 270.11.8/1986 - Release Date: 03/05/09
19:32:00
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|