WHY can't they make anything right?
Not the chinks this time the taiwanese.
Picture my NOS bumper, NOT a repro, but I had to get repro over riders.
I go to install the POS over riders on my NOS bumper and they just do
not fit.
I check my originals on the bumper, they fit fine, the new ones look
just like the old ones. BUT when you look close, the metal bracket
welded inside that holds the captive nut, they whole bracket is off by
3/16" thus you have to modify your NOS bumper AND the POS taiwanese crap
over riders.
Now that I modified the bumper, it doesn't sit well on the bumper iron.
So I had to adjust that, now that I adjusted the iron, it doesn't sit
well on the car, so now I have to modify the bumper mounting brackets.
All because some slant eyed MF can't read.
No I did not get them from mo$$, I would never buy from them.
These came from Vic-Shit.
Why do they do this? other than the guts welded in the wrong spot, (all
4 are the same) they look semi decent. I'm sure they will turn to rust
before the summer gets here but having them rechromed was out of this
world. I hope to find NOS over riders in my future searches for parts at
swap meets.
BTW, to have an AH hub cap rechromes, one that does not need any metal
work and has no dents is $100, that $400 for 4 hub caps. That's a nice
set of fancy wheels.
--
Frank Clarici
Toms River, NJ
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|